NovaStar's current resource set provides MCTRL700 specifications but no separate hardware user manual. The verified NovaLCT manual names the MCTRL700 in its controller workflow. It covers screen setup, receiving-card files, cabinet mapping and saved configuration.
This PDF is the NovaStar NovaLCT configuration manual used for MCTRL700 setup. It is not being presented as a separate hardware manual.
What the MCTRL700 setup manual covers
Screen connection
Connect the controller or sending card to the computer, receiving cards and LED cabinets in the correct order.
Cabinet configuration
Load or create the receiving-card file, set cabinet dimensions and confirm the data path before mapping the full screen.
Screen mapping
Assign cabinets to Ethernet outputs, check the connection order and save the finished configuration to the hardware.
Checks and troubleshooting
Confirm communication, source timing and saved settings before the system is installed or returned to service.
MCTRL700 setup sequence
Check the hardware
Use the datasheet to confirm input format, output count, power and capacity before opening the software.
Connect the control computer
Use the documented USB or network control path and confirm that the device appears in NovaLCT.
Configure one cabinet first
Load a known receiving-card file or complete Smart Setting, then test one cabinet before mapping the wall.
Map and save the screen
Build the cabinet connection map, send it to the hardware and save a backup of the working configuration.
MCTRL700 specifications and limits
Use the specifications table for hardware limits. The manual explains the setup process; it does not replace the model datasheet.
| Document | MCTRL700 Specifications V1.2.2 |
|---|---|
| Inputs | 1× HDMI 1.3, 1× single-link DVI, 1× audio |
| Video loops | HDMI OUT and DVI OUT |
| Maximum total load | 1920×1200@60Hz, 2,304,000 pixels |
| LED outputs | 6× Gigabit Ethernet, up to 650,000 pixels per output |
| Control | USB Type-B and UART cascade up to 20 devices |