Use this manual for source selection, sending-card and fiber-converter modes, Ethernet and optical backup, Genlock, low-latency settings, browser control and NovaLCT or SmartLCT commissioning.
Need the MCTRL660 Pro itself? See current MCTRL660 Pro price and stock on the product page.
Sizing a new wall? Match pixel capacity and ports in the controller calculator.
This is the exact-model MCTRL660 Pro User Manual V1.4.1.
What the MCTRL660 Pro setup manual covers
Screen connection
Connect the controller or sending card to the computer, receiving cards and LED cabinets in the correct order.
Cabinet configuration
Load or create the receiving-card file, set cabinet dimensions and confirm the data path before mapping the full screen.
Screen mapping
Assign cabinets to Ethernet outputs, check the connection order and save the finished configuration to the hardware.
Checks and troubleshooting
Confirm communication, source timing and saved settings before the system is installed or returned to service.
MCTRL660 Pro setup sequence
Check the hardware
Use the datasheet to confirm input format, output count, power and capacity before opening the software.
Connect the control computer
Use the documented USB or network control path and confirm that the device appears in NovaLCT.
Configure one cabinet first
Load a known receiving-card file or complete Smart Setting, then test one cabinet before mapping the wall.
Map and save the screen
Build the cabinet connection map, send it to the hardware and save a backup of the working configuration.
MCTRL660 Pro specifications and limits
Use the specifications table for hardware limits. The manual explains the setup process; it does not replace the model datasheet.
| Document | MCTRL660 Pro Specifications V1.4.1 |
|---|---|
| Inputs | 3G-SDI, HDMI 1.4a and single-link DVI, each with loop-through |
| 8-bit maximum | 1920×1200@60Hz |
| 10/12-bit HDMI/DVI | Up to 1920×1080@60Hz |
| LED outputs | 6× Gigabit Ethernet |
| Optical / sync | 2× 10G main/backup; Genlock IN/LOOP |